Curie’s Law Calculator

Written by Great Medico

Updated September 25, 2026 •2 min read

Share Print Save

Thermal calculations often look simple until absolute temperature, sign convention, phase, or heat-transfer mode changes the meaning. Curie’s Law Calculator keeps the page’s magnetization tied to the quantities and assumptions used by this specific thermodynamic relation.

What this calculator does

The Curie’s Law Calculator brings together Curie constant (C), Magnetic field (B), Temperature, Magnetization around the page’s magnetization. The formula section below identifies which values actually drive that result and which fields are supporting or derived quantities, so you can check the page without assuming every visible box is an independent input.

How to use it

The main fields on this page are Curie constant (C), Magnetic field (B), Temperature, Magnetization. Enter the quantities you actually know, keep their units consistent, and leave derived/output-style fields blank unless the formula explicitly allows solving in the opposite direction. For a clean check of magnetization, change one driving quantity at a time and confirm that the result moves in the direction predicted by the equation.

How the calculation works

The page applies Curie’s law in the form M = C·B/T and also reports susceptibility χ = C/T. Magnetization therefore increases with field strength and falls inversely with absolute temperature in this simplified paramagnetic model.

Example

For example, start with the page’s populated scenario: Curie constant (C) = 1; Magnetic field (B) = 1; Temperature = 300. Apply the equation above using the units shown on the page, then compare the calculated magnetization with the displayed result. As a second check, change one physical input while holding the others fixed and confirm that the direction of change makes sense for this formula.

How to interpret the result

Interpret magnetization within the stated thermodynamic model, unit system, and sign convention. Check whether temperatures are absolute where required and whether the process is idealized, because those details can matter more than the last decimal place.

Limitations and notes

Ideal thermal equations omit some combination of heat loss, contact resistance, temperature-dependent properties, radiation/convection coupling, phase behavior, and nonuniform temperature. Recheck units and process assumptions before using the result for equipment or safety decisions. For Curie’s Law Calculator, keep that general caution tied to the exact fields and equation shown here rather than carrying assumptions over from a different calculator.