Rockwell Hardness Conversion Calculator

Written by Great Medico

Updated September 25, 2026 •2 min read

Share Print Save

A practical rockwell hardness conversion estimate starts with a clear definition of every quantity on the page. Material calculations are most informative when the load path, cross-section, and elastic property all describe the same physical case. Once those inputs are aligned, the calculation becomes much easier to check and compare.

What this calculator does

The Rockwell Hardness Conversion Calculator turns Brinell hardness number (HBS), Vickers hardness number (HV), Rockwell hardness number (HRB) into the page’s estimated hardness conversion using the specific relationship described below. Supporting values appear only where this calculator derives them, which makes the headline easier to audit against the same model.

How to use it

Start with the fields that drive this result: Brinell hardness number (HBS), Vickers hardness number (HV), Rockwell hardness number (HRB). Use the unit menu beside each quantity instead of converting by eye; the page normalizes supported units before calculating. Then change one value at a time and watch whether the headline and supporting values move as the formula predicts.

How the calculation works

The current converter uses rough internal approximations: entered Brinell is taken directly; Vickers is mapped with HBS ≈ 0.95HV; and Rockwell B is mapped with HBS ≈ 2(HRB+80). It then reverses those same approximations for the supporting scales.

Example

The hardness fields are blank by default, so the page returns 0 until a scale value is entered. As a path check, entering 200 HBS makes the same approximation report about 210.5 HV and 20 HRB; those numbers demonstrate the converter’s internal ratios, not a standards-certified equivalence.

How to interpret the result

Treat the displayed HBS, HV, and HRB values as outputs of this page’s rough conversion ratios, not interchangeable certified hardness measurements. A numerical match between two scales does not establish material equivalence because standardized conversions are material- and range-dependent.

Limitations and notes

These are rough empirical conversions, not ASTM/ISO conversion tables. Hardness relationships depend on material class, heat treatment, test range, and scale. Do not use the displayed conversions for engineering acceptance, certification, or a hardness range where the relevant standard gives no valid conversion.